23
2025
04
Common Faults and Maintenance Methods for Electric Actuators
Common Faults and Maintenance Methods for Electric Actuators

Routine maintenance of electric actuators not only extends their service life but also enables preventive measures before failures occur, thereby avoiding unexpected shutdowns that can disrupt production. Common malfunctions and their corresponding maintenance procedures are outlined below:
The electric actuator does not operate.
If the electric actuator fails to operate properly after receiving a control signal, first verify that the power supply is functioning correctly and that the voltage and current meet the specified requirements. Next, inspect the motor for faults, checking whether it is overloaded or damaged. Then, examine the control system to ensure that the signals are accurate and intact. If all these components are in good condition, further investigation may be needed to check the internal reduction mechanism or transmission system, confirming that there is no binding or jamming.
Excessive heating during actuator operation
Electric actuators generate a certain amount of heat during operation; however, overheating can lead to equipment failure. When overheating occurs, first verify whether the motor has been operating at full load for an extended period. If so, consider reducing the load or replacing the motor with one of higher power rating. Also, inspect the actuator’s cooling system to ensure that the heat‑dissipation components are functioning properly, thereby preventing temperature rise due to inadequate cooling.
Position control is inaccurate.
If the position control of the electric actuator is inaccurate, the feedback system may be malfunctioning. Inspect the encoder or sensor to verify that it is functioning properly. If the feedback system is operating correctly, examine the actuator’s control system to ensure the accuracy and stability of the control signals.
Excessive noise
Electric actuators may generate some noise during operation; however, excessive noise is typically caused by wear on transmission components or improper installation. Inspect transmission parts such as gears and lead screws to ensure they are neither loose nor worn or deformed. If necessary, lubricate these components or replace them.
Actuator, electric actuator, transmission system