20
2021
08
Introduction to Maintenance Procedures for Electric Valve Actuators
We employ maintenance practices in many aspects of daily life, and valve actuators, like the electrical appliances we use every day, require regular cleaning and upkeep to extend their service life. Our staff must ensure that these devices remain clean, well-lubricated, fully equipped with all necessary components, and operating normally throughout the year. The following outlines the maintenance procedures for valve actuators:
1. Lubrication of valve actuators: The trapezoidal screw, the sliding interface between the stem nut and the bracket, the bearing areas, the gear–worm wheel and worm meshing points, as well as other mating and moving parts, all require adequate lubrication to minimize friction and prevent wear. Some components are equipped with dedicated grease cups or oil fittings; if these are damaged or lost during operation, they should be repaired or replaced, and the lubrication lines must be kept clear. Lubrication intervals should be determined according to the specific operating environment. For valve actuators that are frequently operated and subjected to high temperatures, it is advisable to replenish lubricant every one to four weeks; for those that are seldom activated and operate at lower temperatures, the lubrication interval may be extended.
2. Maintenance of valve electric actuators: During operation, all components of the valve electric actuator shall be complete and in good condition. Bolts on flanges and supports must be present; their threads shall be undamaged, and no loosening is permitted.
3. Cleaning of valve actuators: The surfaces of valve actuators, the trapezoidal threads on the valve stem and stem nut, the sliding interfaces between the stem nut and the bracket, as well as components such as gears and worm gears, are prone to accumulating dust, oil residues, and deposits from the process medium. These contaminants can cause wear and corrosion. Therefore, it is essential to regularly keep the exterior and moving parts of the valve actuator clean and to protect the integrity of its paint finish.
Some actuators do not have an external power supply, so they can be operated manually. However, most actuators are equipped with a visible position indicator that shows whether the electric actuator and the connected valve are open. Moreover, many valves incorporate internal electronic switches or relays to signal their open or closed positions.
Previous page
Previous page