07

2022

03

What are the common malfunctions of electric control valves, and how can they be resolved?


    Electric control valve It mainly consists of an electric actuator and a control valve. The electric actuator provides the power to drive the control valve, receives on/off and modulating signals from the control system, and adjusts the valve plug to regulate the flow of the medium in the pipeline. During prolonged operation, electric control valves inevitably encounter certain issues. Next, we will outline solutions to common problems.
1. After power is applied, the control signal fails to operate. One possibility is motor failure; you can use a multimeter to measure the motor winding resistance—values of zero or infinity indicate a fault, and this is often due to motor damage. Another possibility is that the butterfly valve disc is jammed by debris in the pipeline; in this case, the pipeline must be dismantled and thoroughly cleaned.
2. The electric control valve does not seal tightly. This is primarily caused by wear of the sealing ring.
3. The control valve cannot be opened. This issue is primarily caused by the newly installed soft-seal control valve, where the flange mounting bolts were tightened during installation, compressing and deforming the rubber seal and causing it to grip the butterfly disc.
4. The electric control valve does not respond to the control signal. If the control signal is confirmed to be functioning properly, replace and inspect the control module. If the module is damaged, install a new one; otherwise, proceed to check the motor.