05

2022

01

Basic Contents of Maintenance and Management for Electric Control Valves


Electric control valve It is an important tool for industrial automation and process control. With the development of China’s industry, the level of automation has continued to rise, leading to its increasingly widespread application across various sectors of electronic manufacturing. When electric control valves fail to meet operational requirements or experience malfunctions during operation, regular inspections should be conducted to prevent accidents. If a prolonged period elapses without maintenance, thorough repairs are necessary. Maintenance management typically encompasses the following key areas of study:
 
1. Valve Cleaning
During maintenance, the valve must be removed from the production line, and its surface exposed to the process medium must be thoroughly cleaned. This is to prevent personnel injury and equipment damage caused by corrosive fluids or other adverse effects. At the same time, any rust on the exposed surfaces of system components should be removed.

2. Valve Disassembly
All components used for inspection are assessed to determine the extent of maintenance and replacement required. First, the actuator and valve should be completely disassembled. During disassembly, care must be taken to protect the precision‑machined surfaces of the valve plug, valve seat, stem, pushrod, sleeve, and other parts to prevent damage and minimize repair costs. A dedicated tool should be used to remove the valve seat.
 
3. The throttle body sealing surfaces, body surface, and seat surface exhibit minimal wear and corrosion. Machining or grinding repairs can also be performed using standard shop equipment. If the damage is severe, the component must be replaced. During repair, ensure proper coaxial alignment between the valve spool and the valve seat.
 
If the valve stem sealing surface is damaged, the part must be replaced with a new one.

Damage has occurred to the pushrod guide and sealing surfaces. The reaction‑type actuator must be replaced with new parts. As for the positive‑action actuator, it can still undergo appropriate repair.

During maintenance, if cracks or other defects that compromise the component’s strength are detected in compressed-air springs, they must be replaced with new ones.

4. Replacement of Wear Parts
Main wear parts of the electric control valve: packing rings, O-rings, gaskets, diaphragms, etc.

During each maintenance inspection, all removed packing, O-rings, and gaskets should be replaced with new components. After the diaphragm is removed, the operator should inspect it for any cracks, signs of aging, or wear that might indicate potential failure, and then decide whether replacement is necessary based on the specific condition. Typically, these components should be replaced every 2 to 3 years at most.
 
5. Assembly and Debugging
During assembly, the positioning components, guide elements, and threaded parts must be securely fastened together. Each component should be coated with an appropriate lubricant to facilitate future maintenance and disassembly by service personnel. Special attention must also be paid to ensuring the coaxial alignment of the pushrod, valve spool, and valve seat within the complete assembly. After installation and commissioning of the electric control valve, it may only proceed to subsequent designated installation steps upon passing the standard factory‑approved test procedures.